This project is continued from Part 3.
With the new soffit and fascia installed, it’s time to rehang the gutter. The gutter was originally fastened with gutter spikes nailed into the rafter tails. Gutter spikes are similar to big nails. The problem with gutter spikes is they tend to work themselves out and become loose.
I used gutter screws to reattach the gutter. Gutter screws won’t back out like smooth spikes and hold better. The gutter screws are on the left and center in the above photo.
Reinstall the Gutter
The old gutter sealant is scraped off the end of the gutter and all dirt is washed off. Do the same for the mating gutter end at the front of the roof.
The corner gutter joint is fastened with aluminum pop rivets: 1/8″ rivets for the face and 3/8″ rivets on the bottom. A pop rivet tool with several head sizes is needed.
The gutter is laid on the roof and the corner fastened with pop rivets, observing the original sheet metal folds. It was important to fasten this end first because it established the “high end” for proper slope and water drainage. I haven’t installed the gutter screws yet because this short section of gutter is light, rigid and the far end sits against and is supported by the roof.
The corner seam of the gutters is sealed with gutter sealant that is applied to the inside of the gutter. Take care to remove the old sealant and dirt before applying sealant from both gutter sections.
Gutter screws are simple to install with a cordless drill/driver. I wasn’t able to get a decent photo working over my head on the 2nd story, though this photo from work I was doing later illustrates the installation. Lift the shingles to double check the screw is aligned with the rafter tail before installing.
The 11 foot section of gutter was short enough that it didn’t sag with the far end resting on the roof, so it wasn’t necessary to chalk a line to maintain the proper slope. In fact, the slope was an aggressive 3/4″ over the 11 foot length.
A view of the scaffold and re-installed gutter with the new soffit and fascia:
The soffit joints are caulked with a paintable exterior grade silicone caulk.
Flashing to Protect the Soffit
TheTUF Board PVC fascia won’t rot if it gets wet, however the plywood soffit will eventually rot if it gets wet.
To prevent rain water from leaking under the fascia and onto the soffit again, I slipped a 4″ x 8″ section of flashing under the shingles and over the gutter end at the roof valley to direct the rain water away from the fascia.
I crawled into the attic during two different rainy periods and confirmed the flashing kept the water out. It worked like great. This bit of flashing cost less than 50 cents and were installed when the house was built it would’ve saved me all this work!
This project is concluded in Part 5.
Thanks for reading,
Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.