This project is continued from Part 11. The rake wall roof corner flashing installation steps are illustrated in this project. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
Tag Archives | ice and water shield
Hail Damaged Roof Replacement: Part 10 – Dormer Roof Flashing
This project is continued from Part 9. The dormer roof flashing details are shown including the stucco step flashing, apron flashing (headwall flashing) and counter flashing installation steps. A section of rotted fascia board is repaired with PVC composite trim board. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
Hail Damaged Roof Replacement: Part 9 – Porch Roof and Stucco Counter Flashing
This project is continued from Part 8. The new porch roof details are illustrated with the stucco apron/headwall flashing and counter flashing installation steps. A section of rotted soffit and fascia board are also replaced. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
Hail Damaged Roof Replacement: Part 8 – Dead Valley and Stucco Wall Flashing
This project is continued from Part 7. Dead valleys are a frequent source for roof leaks and special attention is needed when installing the new roof. Stucco walls require new step flashing and counter flashing. Kickout flashing is installed at the corners and roof end to direct water away from the wall. Copyright © 2013 [...]
Hail Damaged Roof Replacement: Part 5 – Plumbing Vents
This project is continued from Part 4. The shingle roof is being replaced due to hail damage. Ice and water shield is applied over the plumbing vent pipes, new vent boots are installed, then protected from the weather with Dura-Boot vent boots. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
Hail Damaged Roof Replacement: Part 4 – Gas Flue Vents
This project is continued from Part 3. The Type B gas roof vents for the natural gas furnace and hot water heater are replaced with the installation of the new roof. New vent caps, storm collars and flashings are installed. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
Hail Damaged Roof Replacement: Part 2 – Chimney
This project is continued from Part 1. The roof replacement details around the chimney are illustrated. The HardiePlank® siding is pulled off the chimney to install peel-n-stick ice and water shield with new step flashing and apron flashing. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
How to Repair a Leaky Chimney – Part 6
This project is continued from Part 5. View of the ice and water shield, new step flashing and shingles as the roofer works his way around the chimney corner. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
How to Repair a Leaky Chimney – Part 5
This project is continued from Part 4. The Owens Corning WeatherLock® Mat Waterproofing Underlayment (ice and water shield) is installed against the chimney and the roof deck. Notice how the roofers slipped water shield behind the first piece of step flashing and under the shingle to shed water. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
How to Repair a Leaky Chimney – Part 4
This project is continued from Part 3. I decided to pull off and replace the damaged HardiPlank® where it met the roofline on the west face of the chimney. Recall that the siding on the north side of the chimney was previously removed in Part 3. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
Recent Comments