The plywood closet cap is installed in this update of How To Build a Basement Closet. This project is continued from Basement Closet Drywall Finishing. Closet Light Electrical Permit Inspection I filed for a building permit to cover the new electrical circuit for the closet light and left the 2×4 wall and closet ceiling open [...]
This project is continued from Part 9. Bathroom Exhaust Fan Trim Moulding I installed the trim moulding for the Panasonic WhisperCeiling™ FV-11VQ5 bathroom fan with 2 inch brad nails set into the joist and 2×2 mounting frame on three sides. I set the brad nails about 1/4 inch from the inside edge of the trim [...]
This project is continued from Part 7. Bathroom Exhaust Fan Ductwork Connection With the other end of the flexible duct now connected to the outside vent cap, I’m ready to make the final 4 inch vent duct connection inside the interior soffit in the garage. To connect the bathroom fan vent duct in the interior [...]
This project is continued from Part 6. Bathroom Exhaust Fan – 4 Inch Vent Cap The old economy bathroom vent fan used a 3 inch diameter duct and vent cap. The new Panasonic WhisperCeiling model FV-11VQ5 exhaust fan requires a 4 inch diameter duct and vent cap. I purchased a 4 inch vent cap with [...]
This project is continued from Part 10. The installation steps of the roof-to-wall apron flashing for the shed roof extension from the side of the house are described in detail. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
This project is continued from Part 8. The new porch roof details are illustrated with the stucco apron/headwall flashing and counter flashing installation steps. A section of rotted soffit and fascia board are also replaced. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
This project is continued from Part 7. Dead valleys are a frequent source for roof leaks and special attention is needed when installing the new roof. Stucco walls require new step flashing and counter flashing. Kickout flashing is installed at the corners and roof end to direct water away from the wall. Copyright © 2013 [...]
This project is continued from Part 4. The shingle roof is being replaced due to hail damage. Ice and water shield is applied over the plumbing vent pipes, new vent boots are installed, then protected from the weather with Dura-Boot vent boots. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
This project is continued from Part 1. The roof replacement details around the chimney are illustrated. The HardiePlank® siding is pulled off the chimney to install peel-n-stick ice and water shield with new step flashing and apron flashing. Copyright © 2013 HandymanHowTo.com Reproduction strictly prohibited.
This project is continued from Part 5. It’s very important to assemble and glue the solvent weld union fittings in the correct order because you only get one chance to do it right! The large white union nut must be slipped onto the upper section of PVC pipe and held in place so it doesn’t [...]
Recent Comments